Tri-Clamp Clamps

Tri-Clamp clamps, also called Tri-Clover clamps, include single-pin, double-pin, three-piece, spring-lever and two-bolt designs. This range covers the clamp itself. A complete joint also includes two mating ferrules and a gasket.

Tri-Clamp Clamps products

Showing 1–13 of 13 results
Loading products…

Comparing single-pin, double-pin, three-piece & two-bolt clamps

Compare how the clamp opens, how much clearance it needs, and how the fastener is accessed. A single-pin 13MHH opens on one hinge, a three-piece clamp articulates in sections, and a two-bolt clamp uses two fasteners. Confirm the flange profile, gasket and tightening instructions for the selected assembly and service.

Clamp sizing discipline across 1/2" mini to 12" lines

Specify clamp size using both the nominal line size and the ferrule flange OD (C) you measured—for instance, 50.5 mm clamps fit both 1" and 1½" OD-tube ferrules, whereas 25.2 mm mini clamps cover 1/2" and 3/4" mini ferrules.

Key specification checks

  • Single-pin 13MHH clamps speed tool-free washdown; two-bolt or double-pin clamps suit higher bolt preload and tight racks.
  • Verify mini clamp OD (25.2 mm for 1/2" and 3/4") versus standard 50.5 mm (for 1" and 1½").

Filter & browse

Filter by category or jump to collection

Size

Frequently asked questions

When should I choose a two-bolt or three-piece clamp instead of a single-pin 13MHH clamp?

Choose by access to the fastener, mating flange geometry and the requirements of the assembled joint. Send the clamp model and the operating conditions so the complete configuration can be checked.

Do 1" and 1½" Tri-Clamp fittings use the same 50.5 mm clamp?

Yes—on standard inch OD-tube lines, both 1" and 1½" ferrules share a 50.5 mm flange OD, so the 1"–1½" clamp fits around the outside of both joints. The gasket and ferrule bores still remain strictly size-specific.

What do you need to check a replacement clamp for my line?

Send the old clamp designation if readable and photos of both ferrule faces and the clamp groove. Include the actual flange outside diameter and operating pressure, temperature and cleaning cycle so we can check the proposed joint configuration.

LET’S TALK ABOUT YOUR PROJECT

Discuss your Tri-Clamp Clamps requirements

Send a size and quantity list, or describe your BOM and interface requirements. Drawings can follow by email.

Send an inquiry

Known part lists, partial caliper measurements or unknown replacement parts are all welcome.

Photos, drawings or BOM? Submit this form to get an inquiry number, then send files by email.

Cookie & privacy preferences

Choose which storage categories you allow. Privacy policy

NecessaryAlways enabled

Required to remember your privacy preference and active inquiry session.

Preference lifetime
180 days
Inquiry session
30 minutes
Analytics

Helps us understand catalog usage and improve technical pages.

Advertising measurement

Used only when ad campaign measurement is enabled.

About measurement

Analytics and advertising storage remain off until you grant consent.

You can revisit these preferences any time from the footer.