Tri-Clamp Tees, Wyes & Crosses

Equal tees, reducing branch tees, short instrument tees, lateral Y-pieces, and four-way Tri-Clamp crosses for hygienic branching, sensor ports, and manifold distribution.

Tri-Clamp Tees, Wyes & Crosses products

Showing 1–10 of 10 results
Loading products…

Equal tees, reducing tees & short instrument tees

Equal tees maintain full line diameter across run and branch. Reducing tees drop down on the branch outlet for smaller take-offs, while short instrument tees minimize branch projection height for sanitary gauges, diaphragm seals, and thermowells.

Y-pieces and 4-way Tri-Clamp crosses

Sanitary lateral wyes (45° Y-branches) split or merge flow streams with gentler directional change than a 90° branch, while 4-way crosses combine opposing ports and vertical gauge/vent connections in compact skid frames.

Key specification checks

  • Short instrument tees reduce dead-leg volume on pressure gauges, RTDs, and sampling ports.
  • Specify run × branch nominal sizes explicitly on reducing tees and lateral Y-branches.

Filter & browse

Filter by category or jump to collection

Frequently asked questions

Why pick a short instrument tee over a standard Tri-Clamp tee for sensors?

Short instrument tees keep the branch ferrule closely flush with the main tube wall, minimizing stagnant pockets (dead legs) during CIP cleaning.

How should I write dimensions for a reducing tee in my RFQ?

Write Run OD × Branch OD explicitly (for example 2" run × 1" branch Tri-Clamp reducing tee), along with stainless grade (304 or 316L).

How do I show the required branch direction on a tee or wye?

Mark the main flow path and show the branch angle and direction on a sketch. For constrained installations, add center-to-end dimensions and clearance for clamps or instrument removal.

LET’S TALK ABOUT YOUR PROJECT

Discuss your Tri-Clamp Tees, Wyes & Crosses requirements

Send a size and quantity list, or describe your BOM and interface requirements. Drawings can follow by email.

Send an inquiry

Known part lists, partial caliper measurements or unknown replacement parts are all welcome.

Photos, drawings or BOM? Submit this form to get an inquiry number, then send files by email.

Cookie & privacy preferences

Choose which storage categories you allow. Privacy policy

NecessaryAlways enabled

Required to remember your privacy preference and active inquiry session.

Preference lifetime
180 days
Inquiry session
30 minutes
Analytics

Helps us understand catalog usage and improve technical pages.

Advertising measurement

Used only when ad campaign measurement is enabled.

About measurement

Analytics and advertising storage remain off until you grant consent.

You can revisit these preferences any time from the footer.