Tri-Clamp Reducers

Concentric and eccentric sanitary Tri-Clamp reducers in 304 and 316L stainless steel for stepped line transitions, horizontal self-draining runs, and pump suction manifolds.

Tri-Clamp Reducers products

Showing 1–6 of 6 results
Loading products…

Concentric vs eccentric Tri-Clamp reducers

Concentric reducers transition symmetrically around one shared center axis and are standard on vertical risers or balanced manifold drops. Eccentric reducers align one side tangent straight across—installed flat-side-up on horizontal pump suctions to prevent gas pockets, or flat-side-down on process return lines for complete drainage.

Verifying flange clearances on tight dual-size transitions

On steep multi-step reductions (such as 4" × 1½") or short spool reducers, confirm overall end-to-end length and clamp handle sweep radius before fabrication.

Key specification checks

  • State Large End × Small End sizes explicitly (e.g. 2" × 1½" or 4" × 2") and overall length.
  • Choose concentric for vertical lines vs eccentric for horizontal pump inlets and drainable lines.

Filter & browse

Filter by category or jump to collection

Frequently asked questions

Which reducer orientation should I use right before a sanitary pump inlet?

Use an eccentric Tri-Clamp reducer installed flat-side-up on horizontal pump suction lines so trapped air or vapor can travel straight into the pump casing without forming an air pocket.

What does a 4 × 2 Tri-Clamp reducer mean?

It designates the large-end (4" OD tube, 119.0 mm flange) transitioning to the small-end (2" OD tube, 64.0 mm flange). Request the exact end-to-end length on the product order drawing.

Can a 2-inch filter result distinguish a 2 × 1½ from a 4 × 2 reducer?

Both may appear because the filter matches either documented Tri-Clamp end. Use the product configuration or drawing to confirm the exact large and small ends. Specify concentric or eccentric geometry and state the intended orientation when it affects drainage or equipment clearance.

LET’S TALK ABOUT YOUR PROJECT

Discuss your Tri-Clamp Reducers requirements

Send a size and quantity list, or describe your BOM and interface requirements. Drawings can follow by email.

Send an inquiry

Known part lists, partial caliper measurements or unknown replacement parts are all welcome.

Photos, drawings or BOM? Submit this form to get an inquiry number, then send files by email.

Cookie & privacy preferences

Choose which storage categories you allow. Privacy policy

NecessaryAlways enabled

Required to remember your privacy preference and active inquiry session.

Preference lifetime
180 days
Inquiry session
30 minutes
Analytics

Helps us understand catalog usage and improve technical pages.

Advertising measurement

Used only when ad campaign measurement is enabled.

About measurement

Analytics and advertising storage remain off until you grant consent.

You can revisit these preferences any time from the footer.