Tri-Clamp Gaskets & Seals

Tri-Clamp gaskets and seals, also called Tri-Clover gaskets, include plain, outer-lip and mesh-screen profiles. Match the mating ferrule bore and gasket profile before selecting a compound for the process and cleaning cycle.

Tri-Clamp Gaskets & Seals products

Showing 1–8 of 8 results
Loading products…

Why Tri-Clamp gaskets are isolated from BSM, RJT & DIN union seals

Tri-Clamp gaskets seal between two flat ferrule grooves with twin circular compression beads, whereas BSM unions seat stepped/flat rings inside threaded liners and RJT unions rely on circular O-rings. Isolating the 8 dedicated Tri-Clamp gasket series here prevents ordering incompatible union seals by mistake.

Selecting EPDM, Silicone, FKM (Viton), PTFE & mesh screen compounds

Start with the mating profile and actual bore. Then list the process fluid and each cleaning exposure separately. For EPDM, silicone, FKM or PTFE, provide the media, cleaner concentration, temperature and contact time so the compound can be checked. For a screen gasket, also specify the mesh requirement.

Key specification checks

  • Choose outer-lip flanged seals to hold the gasket centered during vertical or overhead assembly.
  • Use PTFE or FKM mesh screen gaskets ahead of spray balls, fillers, and positive-displacement pumps.

Filter & browse

Filter by category or jump to collection

Frequently asked questions

Can I use a BSM or RJT seal inside a Tri-Clamp joint?

No. BSM and RJT seals have completely different groove seats and cross-sections and will extrude or leak if clamped between Tri-Clamp ferrules.

Why are 1" and 1½" 50.5 mm Tri-Clamp gaskets not interchangeable?

While both outer rims are 50.5 mm, the 1" gasket inner bore (~22.2 mm) obstructs a 1½" line (34.8 mm bore) and a 1½" gasket leaves a stepped gap inside a 1" ferrule groove.

When should I choose an outer-lip flanged gasket or mesh screen gasket?

Use outer-lip flanged silicone or FKM gaskets when assembling vertical risers or overhead racks single-handedly so the lip grips the ferrule rim concentrically; use PTFE or FKM stainless-mesh gaskets where compact inline straining is needed.

How do I identify a replacement gasket when the compound is unknown?

Send a face-on photo of the existing gasket and ferrule with scale, the gasket bore, and the process and cleaning conditions. A worn gasket or its color alone cannot establish the original compound or exact size.

LET’S TALK ABOUT YOUR PROJECT

Discuss your Tri-Clamp Gaskets & Seals requirements

Send a size and quantity list, or describe your BOM and interface requirements. Drawings can follow by email.

Send an inquiry

Known part lists, partial caliper measurements or unknown replacement parts are all welcome.

Photos, drawings or BOM? Submit this form to get an inquiry number, then send files by email.

Cookie & privacy preferences

Choose which storage categories you allow. Privacy policy

NecessaryAlways enabled

Required to remember your privacy preference and active inquiry session.

Preference lifetime
180 days
Inquiry session
30 minutes
Analytics

Helps us understand catalog usage and improve technical pages.

Advertising measurement

Used only when ad campaign measurement is enabled.

About measurement

Analytics and advertising storage remain off until you grant consent.

You can revisit these preferences any time from the footer.